[neggard]

Hello everybody.

I have just installed
http://www.dd-wrt.com/dd-wrtv2/downloads/v24-sp1/Professional/X86/public/dd-wrt_public_serial.image

My hardware is
http://www.pcengines.ch/wrap1e203.htm
and I have a wifi card installed
http://www.unex.com.tw/product/cm9-gp

Now to my questions.

Do I need to buy an activation to get my wifi card working?
Now I dont even see the wifi options in my dd-wrt control panel

Does my card work with dd-wrt?

Is there a list of thruput WAN --> LAN ?

If I need to buy an activation what should I buy?

[Sash]

[neggard]

I installed the full serial non smp version and buy an activation.
Everything seems to work well but I have a question about WAN.

When I installed the public version everything works great until I plugged in my WAN cable.
I have also change connection type to DHCP.

When this was done I cold not connect to dd-wrt anymore, even if I reboot and unplugged my WAN cable it dont work.

So how do I know which eth who is WAN.
Usually it should be the last (nr 3) But I want to be sure so I dont need to reinstall everything again.
Is there a setting I have forgot to do in the dd-wrt control panel?

[Sash]

setup>networking

[neggard]

I can just say WOW!!!
Lots of settings for wireless :)

My problem now is to get my wifi clients to get IP from DHCP but I have to try different settings.

The question I have about thruput WAN --> LAN was not the right answer I want ;)

My wrap board is 233MhZ and I get about 15Mbit thruput,
how much is needed for 100Mbit thruput?

[Sash]

working N-2.0 cards on both ends and >400mhz