Netgear WG602 v3/4
From DD-WRT Wiki
Revision as of 20:47, 12 June 2011 (edit) Donny (Talk | contribs) (→Firmware - Updated file to 14929 as 13575 is no longer available) ← Previous diff |
Revision as of 20:07, 22 June 2012 (edit) (undo) Glenn (Talk | contribs) (+ Category:Netgear guides) Next diff → |
||
Line 57: | Line 57: | ||
#*login and configure | #*login and configure | ||
#remember to re-enable firewall, antivirus, and dhcp on the computer | #remember to re-enable firewall, antivirus, and dhcp on the computer | ||
+ | |||
+ | [[Category:Netgear guides]] |
Revision as of 20:07, 22 June 2012
Someone who has this router should write a proper wiki entry on how to upgrade, but until that is done, here is a link to some basic information
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=475282
dd-wrt Firmware Replacement on Netgear WG602v3 Wireless Access Point
Augur 11:34, 30 August 2010 (CEST)
Contents |
Read This First
READ the Peacock Thread first.
use the wiki and forums to do research before even contemplating installing dd-wrt
check the WG602v3 works before flashing
check your WG602v3 matches the details in the [Supported Devices page]
Firmware
the WG602v3 only has 2mb flash memory so can only support the micro builds
BrainSlayer builds (14929) dd-wrt.v24_micro_generic.bin
ftp://dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2010/08-12-10-r14929/broadcom/
[dd-wrt.v24_micro_generic.bin]
using [tftp2.exe]
Preparing The WG602v3
- connect the WG602v3 to a computer using a network cable
- set static ip of computer to 192.168.0.220/24
- there should be no means of access to any other router or dhcp server or the WG602v3 will not set its default ip address.
- perform a [30-30-30 Hard Reset]
- in browser go to http://192.168.0.227 L:admin P:password and check it is the default netgear setup
Installing dd-wrt
- on the computer disable firewall and antivirus
- run tftp2.exe
- configure as follows
- Server to 192.168.0.227
- password leave blank
- pick the firmware
- set rety to 50
- open a command prompt and type in ping 192.168.0.227 -t
- unplug power lead from router
- replug power lead into router
- the instant you get a ping response from the router click Upgrade
- if it doesn't work try unplugging again (timing matters)
- stop pinging the router (ctrl-c)
- (very important) wait 5-7 minutes after you get the success message before doing anything. recomend you walk away and get a drink
After Install. Initial Preparation Before Use
- reconfigure the static ip of the computer to 192.168.1.220/24
- in browser go to http://192.168.1.1
- if you get the dd-wrt web gui password change page perform a power cycle on the router
- when the web gui comes up again perform a 30-30-30 hard reset
- wait for gui to come up again
- change default username and password
- close browser
- open browser and load the gui again. you should now have the status screen
- login and configure
- remember to re-enable firewall, antivirus, and dhcp on the computer